FS#4527 - Add hotkeys to signal GUI

Attached to Project: OpenTTD
Opened by Yorick (yorick) - Monday, 21 February 2011, 14:51 GMT
Last edited by andythenorth (andythenorth) - Monday, 14 August 2017, 20:32 GMT
Type Patch
Category Interface
Status Closed
Assigned To andythenorth (andythenorth)
Operating System All
Severity Very Low
Priority Normal
Reported Version trunk
Due in Version Undecided
Due Date Undecided
Percent Complete 0%
Votes 1
Private No


The attached patch (apply with -p1) adds support for a cycle signal type and conversion toggle hotkey to the signal GUI. The cycle_signal_type also follows the advanced setting.
This task depends upon

Closed by  andythenorth (andythenorth)
Monday, 14 August 2017, 20:32 GMT
Reason for closing:  Won't implement
Additional comments about closing:  Mass closure of patch tickets with no commentary for >5 years. Goal is to reduce patch queue as an experiment to see if it aids faster reviewing and rejection/acceptance (it may not). If this offends you and the patch is maintained and compiles with current trunk, discuss with andythenorth in irc. (andythenorth has no ability to review patches but can re-open tickets).
Comment by CyberSoul (CyberSoul) - Sunday, 13 March 2011, 18:44 GMT
This is such a great idea that I had already coded the simple convert signal hotkey myself. It would be great if this was included for the heaviest signal users. If you prefer, I have a version that implements the hotkeys more like the main rail toolbar. So signal cycling is a widget enum in onclick, and then the key events relay through there.